Laundry
How to clean front-loader washing machine mold (gasket, drawer, and drum)
Front-load washers get a sour smell when soap residue, lint, and moisture sit in the rubber door gasket and the detergent drawer. The mold you can see on the fold of the seal is the same problem as the odor you notice when you open the door. Clean those parts, run a hot maintenance cycle, and then change the habit that keeps the drum wet.
Some product links below go to Amazon and may become affiliate links. If you buy through an affiliate link we may earn a commission at no extra cost to you. See our affiliate disclosure.
What you are actually cleaning
The drum itself is only part of the story. The gasket’s inner fold collects hair, coins, black mildew spots, and leftover suds. The detergent drawer has hidden tunnels. The door glass stays damp if you close it on a wet machine. Too much detergent, or a regular detergent in an HE machine, leaves a biofilm that smells even when you cannot see much mold yet.
The gasket, the drawer, and the glass
- Unplug the machine if you are more comfortable that way, and skip this job while a cycle is running.
- Open the door and gently pull back the rubber gasket, all the way around, including the bottom. Wipe out grit and hair with a cloth. For the black spots, use a cloth dampened with a 1:10 dilution of regular household bleach and water, or a cleaner the manufacturer allows, and keep the room ventilated. If you prefer to avoid chlorine, an oxygen bleach powder solution (mixed as the box directs) or a dedicated washing-machine cleaner used on a cloth can improve light growth; stubborn staining in rubber sometimes will not bleach back to new.
- Rinse the gasket with a cloth dampened in clean water and dry it. Look for a small drain hole at the bottom of the seal and make sure it is not packed with sludge.
- Pull the detergent drawer out (there is usually a release tab). Wash it in the sink with hot water and dish soap, and scrub the underside and the fabric-softener chamber with an old toothbrush. Wipe the cavity in the machine where the drawer sits; that pocket is often worse than the drawer.
- Wipe the door glass and the front edge of the drum.
Do not mix bleach with acids or with leftover detergent experiments If you already used vinegar in the drum, run a rinse or wipe the surfaces with water before any chlorine bleach. Never pour bleach and vinegar into the same washer. Keep bleach off your colored laundry and off your hands and floors; wipe drips immediately.
The hot maintenance cycle
After the gasket and drawer are clean, run the machine’s tub-clean or sanitize cycle if it has one. If it does not, run the hottest, longest empty cycle the manual allows. Use the product the manufacturer recommends—often a washing machine cleaner tablet or powder, or a measured amount of bleach or oxygen bleach as the booklet specifies. This is the step that treats the drum and, as far as a home cycle can, the parts you cannot reach with a cloth.
Some manuals allow a vinegar maintenance wash; others warn against regular vinegar or “essential oil” refreshers in front-loaders. Follow the booklet. Vinegar is useful in many household jobs, as we cover in natural cleaners that actually work, but a rubber gasket and a closed, unvented drum are not the place to improvise a chemistry set.
Use less detergent HE washers need a small amount of HE detergent. More soap does not get clothes cleaner in a low-water machine; it leaves residue that feeds odor. If you see suds in the glass mid-cycle, you are probably using too much. Softeners and pods can also leave a film; follow the dose marks and skip extra “scent booster” until the smell is under control.
The habit that keeps it from coming back
- Leave the door ajar between loads so the drum can dry. If you have a curious child or a pet, crack it when you are home and close it when you need to.
- Leave the detergent drawer slightly open as well.
- Wipe the gasket dry after the last load of the day, especially the bottom fold, if anyone in the house is sensitive to mildew or you have already had a mold problem.
- Do not let wet clothes sit in the machine overnight.
- Run a maintenance cycle about once a month, or whenever the maker suggests, and inspect the gasket at the same time.
Put that monthly cycle on the same deep-clean list as the other appliance jobs in the weekly house cleaning schedule. If the laundry room itself is damp and unventilated, a cleaner gasket will still struggle; run the room fan or open a door after you wash.
When cleaning is not enough
If the gasket is torn, permanently stained and slimy, or pulling away from the drum, replacement of the seal is often cheaper than living with the smell—and it is a common repair. If odor remains after a careful clean, a maintenance cycle, and a week of drying habits, the problem may be in the drain pump filter (many front-loaders have a small access door at the bottom front; put a pan under it before you open it) or in standing water in a hose. Check the manual before you open a pump filter; you can get a burst of dirty water.
Supplies
- Microfiber cloths, an old toothbrush, and dish soap for the drawer
- A manufacturer-approved washing machine cleaner, or bleach / oxygen bleach as the manual allows
- A small bowl or cup for a measured bleach dilution if you are wiping the gasket
- Gloves if you are using chlorine bleach, and ventilation

Put the schedule on the fridge
The MakeClean Cleaning Planner is a printable weekly and monthly checklist—same system as this site, ready to write on. Digital download, $7.
instant download
Launch offer: use code LAUNCH30 at checkout for 30% off the planner, until November 30, 2026.
Buy now — $7 See all printables
Secure checkout by Payhip (card or PayPal)
FAQ
Why does my front-loader smell like mildew even when it looks clean?
Odor often lives in the hidden fold of the door gasket, in the detergent-drawer cavity, or in leftover soap film inside the drum. Clean those, run a hot maintenance cycle with the right cleaner, use less HE detergent, and leave the door and drawer open so the machine can dry.
Can I use vinegar to clean a front-load washer?
Some manuals allow an occasional vinegar rinse; some advise against it because acid can affect rubber seals and certain parts over time. A product the manufacturer lists for a tub-clean cycle is the safer default. Never mix vinegar with bleach.
How often should I clean the gasket?
Wipe and dry the gasket whenever you notice residue, and inspect it at least monthly when you run a cleaner cycle. If you already have mildew spots, clean them now and then keep the door ajar so they are less likely to return.
Is the black stuff on the seal dangerous?
It is usually mildew or mold growing in a damp, soapy fold. Clean it with the method your manual allows, improve drying, and replace a gasket that stays slimy or crumbling. If anyone in the house has a mold allergy or asthma and the problem keeps returning, take that seriously and fix the moisture, not just the stain.
Do I need bleach in every wash to prevent mold?
No. Everyday bleach in every load is hard on some fabrics and is not a substitute for drying the gasket and dosing detergent correctly. Save chlorine for a measured, manual-approved maintenance wipe or cycle, not as a daily additive.

Get the checklists on paper
The Home Printables Bundle includes the planner, move-out checklist, kids' chore chart, and seasonal checklist — $16, save $8 versus buying them separately.
instant download
Launch offer: use code LAUNCH30 at checkout for 30% off the bundle, until November 30, 2026.
Buy now — $16 See all printables
Secure checkout by Payhip (card or PayPal)
Free: a 15-minute daily reset you can keep on messy weeks
Get the free two-page checklist (US Letter). The daily list plus a simple weekly glance — and a path to the full $7 planner if you want the rest of the system.